Category: Tinware

Rigid Velocette Top Yokes for WEBB forks

Somebody please help. I am trying to get the one or other thing produced for rigid Velocette’s and would prefer, if possible, to be able to initiate or keep (once established) the production process here in the UK, close to the market centre and close to central distribution-channels. I am not able to manufacture anything…


GTP Drive-side completion

Let’s get this drive-side finished! YES! With just a small job to do on the gearbox, to stop the mainshaft falling out! Basically, the lid has to be put on the gearbox: so to start with, first gear is stuck, lubricated, on the end of the shaft: The gasket face is then cleaned up with…


Miller Regulator Cover and More!

Old lid with new internals (no bracket yet!) How time flies!! I am still stuck up here at my parent’s place, camping on an air-mattress that decided to deflate twice last night (No, not the subject of another blog, sorry!) and am sitting right now at what has, for the last eight months, been my…


‘Racing’ Oil Tank Anyone??

Hah! Really looks the racing-part! This came with my KSS parts from NSW and the now unresponsive Bob. Ishall actually be selling this, as I have no use for it at all. My bike will be anything but a racer and will probably end up being ‘de-tuned’ mildly, to allow some long-distance cool running with…


New 8″ Headlamp Brackets

Yes, that’s right! Just a quicky! Well, today was a good day… I picked up the initial batch of Headlamp-Brackets (or stays as some will still insist on calling them!) for the WEBB forks and Miller 8″ headlamp, so good for Velocette, Norton, Triumph and other manufacturers also on their pre-war Girders. NOT, I might…


8-inch Miller Headlamp

How good are the copies? Well, I have the undoubted pleasure of owning an original Miller lamp shell, with an original ammeter and switch, (the ammeter pictured above is a cheap pattern which doesn’t fit…) although the switch is a later, three-position job, as available now ‘everywhere’ in pattern form; where from I don’t know…probably…


Miller Rear Light Update

A Much Better Rear Light – From Taiwan Not that anyone would (not) notice the difference in the quality of these two parts, without me saying anything about them, but here goes anyway!! Unless you see them side-by-side, how would you know? The one on the right, needless to say, is the one of Indian…


Going (not so) cheap

I can’t afford to buy rubbish! I wonder what it is (apart from sheer profiteering) that makes people continue to produce absolute trash and why others will fall for it, time and again?? Where does the cycle end? Surely there is a limit reached (à la 100 monkeys), where the charlatans and their dirty dealings…


More Sorting Out

Checking parts for fit… Well, it’s been a busy week, what with this and that! The visit to Pud’s place was a highlight in more ways than one, but more of that later… I got stuck in with the back wheel setup, after turning a longer thread on the spindle and cutting it off appropriately…


Velocette Mudguards and Stays

Something else I need to either make or find a reliable source for! Have a good look at the picture…again! Open and close your eyes a few times to get it right…it’s the INSIDE of the main rear mudguard for the KSS, kindly loaned for measuring up by a good friend, Keith. This picture (got…