Tag: Classic Bikes

Footrest/Kickstart Rubber B60/2

Ready to go! This part is ready to have the tooling made, if there is enough interest! As a first move forward in the Ukraine setup might be this prewar kick-start/gear-change rubber B60/2, which for at least twenty years has been sold under this part-number with a closed end… which is completely wrong! And yes,…


Brooklands day!!

LOTS of Velocettes at Brooklands… For those of you a little too far away to catch the ‘action’ at Brookands, whether at ‘home’ or abroad, here are a few pictures of the event. The pictures speak for themselves for the most part and will require little extraneous comment! The weather was beautiful spring-time stuff, with…


Rigid Velocette Top Yokes for WEBB forks

Somebody please help. I am trying to get the one or other thing produced for rigid Velocette’s and would prefer, if possible, to be able to initiate or keep (once established) the production process here in the UK, close to the market centre and close to central distribution-channels. I am not able to manufacture anything…


Lycett type saddles etc.

The ‘right’ saddle. Let’s face it, if we actually use our machines, one of the things that gets a fair amount of wear and tear, is the saddle. Whichever type we have fitted, at some stage it will need re-covering. There are new covers available which are of a reasonable shape and size, but somehow…


Saved rigid MSS from Australia

   The the old year is gone … and can be done and dusted. A strange mix for me, towards the end more and more challenging. The time of year when I should be doing my own bike and helping others do theirs, ‘God willing’, has left me with a logistically difficult re-location which has…


GTP ‘Before and After’ Album

Ode to a Motorsickle… Well, long promised and never seen the light of day before, here are the pictures Pud took of the GTP when he first got it back in 1968. Not in a sorry state, but 30 years old already and ‘well used’, and not exactly with a very high mileage, about 10.000….


Rigid Velocette gearbox ‘field-strip’

Promises, promises… I had promised that I would describe a quick ‘field-strip’ of a gearbox, in this case the one on the GTP, which is similar to all other pre-swingarm models. Actually the swingarm models are very similar and only differ in detail from this procedure. First to come off are the footrest and gear-change…


GTP all back together

Once the kickstart has been put back together… The rest is actually a doddle. The kickstart disassembly was only really an excuse to demonstrate how it goes back together (spot the deliberate mistake) but shows how the manufacturers actually thought about the tasks of the assembly and service during the design process, as much as…


GTP Drive-side completion

Let’s get this drive-side finished! YES! With just a small job to do on the gearbox, to stop the mainshaft falling out! Basically, the lid has to be put on the gearbox: so to start with, first gear is stuck, lubricated, on the end of the shaft: The gasket face is then cleaned up with…


GTP Primary Chain Case re-assembly

Now the real fun starts! Let’s put this jigsaw back together! Please be patient, there are a lot of hi-res pictures to load on this one!! There are a couple of points to watch that, being a Velocette, it has in common with most of the other models (regarding the clutch at any rate) and…