Category: Repairs

Rigid Velocette Top Yokes for WEBB forks

Somebody please help. I am trying to get the one or other thing produced for rigid Velocette’s and would prefer, if possible, to be able to initiate or keep (once established) the production process here in the UK, close to the market centre and close to central distribution-channels. I am not able to manufacture anything…


Saved rigid MSS from Australia

   The the old year is gone … and can be done and dusted. A strange mix for me, towards the end more and more challenging. The time of year when I should be doing my own bike and helping others do theirs, ‘God willing’, has left me with a logistically difficult re-location which has…


Rigid Velocette gearbox ‘field-strip’

Promises, promises… I had promised that I would describe a quick ‘field-strip’ of a gearbox, in this case the one on the GTP, which is similar to all other pre-swingarm models. Actually the swingarm models are very similar and only differ in detail from this procedure. First to come off are the footrest and gear-change…


GTP all back together

Once the kickstart has been put back together… The rest is actually a doddle. The kickstart disassembly was only really an excuse to demonstrate how it goes back together (spot the deliberate mistake) but shows how the manufacturers actually thought about the tasks of the assembly and service during the design process, as much as…


Velocette Kickstart reassembly

What a pig! The timing side is really not that difficult anymore, apart from the stupid (duh) mistake that I made with the kickstart… The bane of my life. Why can’t I just leave well alone?? Ah well, better get on with it then. Always a struggle for me, the kickstart quadrant remained a mystery…


GTP Drive-side completion

Let’s get this drive-side finished! YES! With just a small job to do on the gearbox, to stop the mainshaft falling out! Basically, the lid has to be put on the gearbox: so to start with, first gear is stuck, lubricated, on the end of the shaft: The gasket face is then cleaned up with…


GTP Primary Chain Case re-assembly

Now the real fun starts! Let’s put this jigsaw back together! Please be patient, there are a lot of hi-res pictures to load on this one!! There are a couple of points to watch that, being a Velocette, it has in common with most of the other models (regarding the clutch at any rate) and…


GTP full gearbox strip-down

Well, blow me down. Four days and nights I have been beating myself up about not stripping the ‘box while it was out of the frame and at four this morning, it finally got me. So I decided that, between everything else going on here (including storms, blocked drains, trees falling all over the place…


GTP Gearbox cure…

So now I have the bike sans gearbox and drive-components on my improvised stand. And what a beauty it is, too. I must admit to having fallen in love with it, such grace and elegance, so well thought out and the solutions to save weight at NO expense to rigidity of the whole plot, simply…


GTP and pre-War MOV single-plate clutch

It is certainly not every day that anyone gets the chance to have a look at and dismantle a Velocette single-plate clutch, as fitted to the pre-war MOVs and the GTP series of bikes, so I thought that while I’m at it, I could take a few pictures and document what it looks like and…